UEFA TV

List of the contents of this article:

• 1,UEFA TV How to open the engine cover of Langyi
• 2, Volkswagen Touareg front cover opening illustration, how to open the Touareg hood
• 3, How to disassemble the Land Rover engine? The notes are summarized as follows
• 4, How to open the engine cover of Langyi
• 5, How to open the Volkswagen Touareg engine cover, Volkswagen Touareg engine compartment diagram

1. The hood switch of Land Rover is in the car and needs to be turned on manually, and the position of the switch is around the foot pedal.There is a switch button on the left side of the pedal. We can press the switch to open the outer hood. Put the hydraulic cylinder of the hood into the groove of the hood to support it.

2. The engine hatch switch of Volkswagen Touareg is located in the lower left corner of the driver's seat. As shown in the figure below, we can lift the opening handle along the arrow, lift the engine cover and open it, then remove the engine hatch support rod from its fixed bracket, and finally hang the engine hatch support rod into the display. In the groove of the motor hatch.

3. How to open the front hood of Volkswagen Touareg: To open the hood of SAIC Volkswagen Touareg, you need to enter the main driver's seat, find the hood switch at the bottom left, and lift the hood switch. Next, when you walk to the hood of SAIC Volkswagen Touareg, you can see a notch.

4. The engine hood switch of Volkswagen Touareg is located in the lower left corner of the driver's seat. As shown in the figure below, we can lift the handle along the arrow, lift the engine hatch and open it, then remove the engine hatch support rod from its fixed bracket, and finally hang the engine hatch support rod into the display. In the groove of the motor hatch.

Volkswagen Touareg front cover opening illustration, how to open the Touareg hood

The hood switch of Volkswagen Touareg is located in the lower left corner of the driver's seat. As shown in the figure below, we can open the handle along the arrow and lift the engine compartment. Cover and open it, then remove the engine hatch support rod from its fixing bracket, and finally hang the engine hatch support rod into the groove indicating the engine hatch.

The hood switch of Volkswagen Touareg is located in the lower left corner of the driver's seat, as shown in the figure below. We can lift the opening handle in the direction of the arrow, lift the hood to open it, then remove the hood support rod from its fixing bracket, and finally hang the hood support rod into the groove showing the hood.

To open the hood of SAIC Volkswagen Touareg, you need to enter the main driver's seat of the vehicle first and find the hood switch at the bottom left. Next, according to the operation method in the figure below, lift the hood switch of SAIC Volkswagen Touareg, and you can pop up the hood latch of SAIC Volkswagen Touareg.

The hood switch is in the car and needs to be turned on manually. The position of the switch is around the foot pedal. You can see that there is a switch button on the left side of the foot pedal. Press the switch to open the outer hood.

The switch of the Volkswagen Touareg hood is in the car, on the left side of the driver's seat. 02 On the left side of the foot pedal, we can see a device similar to a handle. If you open the handle along the arrow, the hood switch will open. 03 Then lift the hood by hand and support it with a hydraulic cylinder.

How to disassemble the Land Rover engine? The notes are summarized as follows

The method of replacing the hydraulic top cylinder of Volkswagen Touareg engine: First, open the engine hood and use a wrench to disassemble the screws on the engine top cover. Secondly, remove the air filter, disassemble the airtight chamber cover and camshaft, and take out the piston. Finally, remove the lever above, then remove the hydraulic top cylinder and operate the installation direction.

Open the timing engine cover of Volkswagen Touareg, look at the screws on the left and right, and remove the engine cover to be removed.

First, open the engine cover of the 09 Land Rover timing. Secondly, look at the screws on the left and right and remove them. Then remove the engine cover and remove the shell.

After removing the iddler, there is a bearing inside. Finally, hang the new belt, hold the tensioning wheel with the previous plum wrench, and then install the idler that has just been disassembled. What is the engine model of Land Rover Plus? Land Rover Plus is equipped with 5L and 4T engines, both of which belong to the EA211 series.

CFB engine is also the first generation of 4T. The water pump is in the middle and rear position on the crankshaft pulley side, and is driven by the crankshaft pulley through the belt, so the belt should be removed first, and then the pump should be pumped, but it is best to loosen the screw of the pump pulley before removing the belt.

How to open the engine cover of Land Rover

1. The hood switch is in the car and needs to be turned on manually, and the position of the switch is around the foot pedal.There is a switch button on the left side of the pedal. We can press the switch to open the outer hood. Put the hydraulic cylinder of the hood into the groove of the hood to support it.

2. Turn on the switch of the engine cover to turn it on. The Volkswagen Touareg engine cover switch is in the cab, and the light switch is below. You can open the engine cover by pulling the latch, and use the toppost to hold the engine cover. The engine cover has the function of protecting the engine and the effect of soundproofing.

3. The engine hatch switch of Volkswagen Touareg is located in the lower left corner of the driver's seat. As shown in the figure below, we can lift the handle along the arrow, lift the engine hatch and open it, then remove the engine hatch support rod from its fixed bracket, and finally hang the engine hatch support rod into the display. In the groove of the motor hatch.

How to open the Volkswagen Touareg engine cover, Volkswagen Touareg engine compartment diagram

The engine compartment switch of Volkswagen Touareg is located in the lower left corner of the driver's seat. As shown in the figure below, we can follow Lift the opening handle on the arrow, lift the engine cover and open it, then remove the engine cover support rod from its fixed bracket, and finally hang the engine cover support rod into the groove indicating the engine cover.

The hood switch of Volkswagen Touareg is located in the lower left corner of the driver's seat, as shown in the figure below. We can lift the opening handle in the direction of the arrow, lift the hood to open it, then remove the hood support rod from its fixing bracket, and finally hang the hood support rod into the groove showing the hood.

The hood switch is in the car and needs to be turned on manually. The position of the switch is around the foot pedal. You can see that there is a switch button on the left side of the foot pedal. Press the switch to open the outer hood.